Responsibilities 

System alignment 

• Aligning the components of the HPSM and drive laser system after the commissioning phase;
• figuring out the cause of not meeting system specifications;
• monitoring and fine-tuning system components and settings (hardware, software, electronics, fluids and gasses);
• delivering a complete system according to the requirements and specifications. Site Acceptance Test;
• performing SAT measurements after the complete installation and final configuration;
• performing physical and performance tests, using a set of predefined test activities, developed to drive the execution of the test item to meet test objectives;
• measuring and examining installed systems, using complex measuring equipment;
• checking main parameters, system settings and functionalities, using predefined acceptance test procedures;
• comparing the actual results with the expected results and evaluating the outcomes to determine if the system’s requirements and specifications are met;
• providing confidence that the product meets both the functional and non-functional requirements;
• reporting progress or possible problems to Technical Coordinator or responsible office staff;
• maintain close communication to 3rd and 4th line support on advanced issues in case solving these locally proves to be difficult;
• coaching and instructing less experienced engineers on performing the same tasks;
• preparing the Drive Laser for customer handover under specific conditions. 

Product development 

• Proposing possible product changes to simplify the testing, increase efficiency or to increase service possibilities;
• reporting product improvements in additional documents;
• giving feedback on received procedures and protocols;

Administration 

• Writing test reports and filling in the respective documents;
• sending final SAT report to the headquarters for approval;
• timely reporting of hours worked and provided work in SIS. 

Functie-eisen

Experience 

• HBO level
• knowledge of machine building;
• technical knowledge of laser products;
• detailed Knowledge of driver laser systems;
• knowledge of the English language;
• knowledge of alignment and testing techniques;
• knowledge of system building.

Direct reageren op deze vacature